DieHard 200.71223 소유자 매뉴얼 - 페이지 11
{카테고리_이름} DieHard 200.71223에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71223 17 페이지. Battery charger 12/2 amp fully automatic microprocessor controlled engine starter 75 amp
페이지 인쇄
Charging your battery removed from
the vehicle:
POSITIVE
NEGATIVE
II
24", 6 GAUGE
II
\
U
U\
GROUNOEO
POWER
OILrFLET
1. Note the poladty of the battery posts
by checking the identification marks
on the battery: POSITIVE (POS, P or
+) and NEGATIVE (NEG, N or -). The
positive post is usually larger than
the negative post.
2. Attach at least a 24-inch-long 6-
gauge (AWG) insulated battery cable
to NEGATIVE (NEG, N or-) battery
post. Rock and twist the clamp back
and forth to be sure a solid electrical
connection is made.
3. Connect the red (POSITIVE) output
clamp to the POSITIVE battery post.
Rock and twist the clamp back and
forth to be sure a solid electrical
connection is made.
4. Position
yourself
as far away from
the battery
as possible,
and then
connect
the black (NEGATIVE)
output clamp to the free end of the
cable.
5. Plug the power cord into an AC
outlet. The charger will set to the
default state of 2 AMP charge rate
and Type 1 for battery type.
6. Press the appropriate
control
buttons
to select the desired
charge
rate and
battery
type. Within
a few seconds,
the red LED should
go out and the
charging
process
should
start. If the
red LED does not go out, check
for
correct
cable connection.
.
.
To disconnect the charger, unplug
the charger power cord before
attempting to disconnect the charger
clamps. Then, standing away from
the battery, remove the output clamp
from the NEGATIVE battery post.
Finally, remove the output clamp
from the POSITIVE battery post.
Clean and store the charger in a dry
location,
USING
ENGINE
START
Your battery charger can be used to
jump start your car if the battery is low.
Follow these instructions on how to use
the ENGINE START feature.
IMPORTANT:
Follow all safety instruc-
tions and precautions when charging
your battery. Wear complete eye
protection and clothing protection.
Charge your battery in a well-ventilated
area.
IMPORTANT:
Using the ENGINE
START
feature
WITHOUT
a battery
installed
in the vehicle
could cause
damage
to the vehicle's
electrical
system.
.
With the charger
plugged
in and
connected
to the battery
of the
vehicle,
press the 75 AMP touch pad.
Only the 75 AMP indicator
lamp
should
be lit.
,
.
.
Crank the engine for no more than 3
seconds. If engine does not start, let
rest for 4 minutes before cranking
again.
After the engine starts, unplug the
power cord before disconnecting the
output clamps from the battery.
Clean and store the charger
in a dry
location.
11