DieHard 200.71223 소유자 매뉴얼 - 페이지 5
{카테고리_이름} DieHard 200.71223에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71223 17 페이지. Battery charger 12/2 amp fully automatic microprocessor controlled engine starter 75 amp
페이지 인쇄
It is important to understand your charger's requirements. This section will tell you
about your charger's electrical requirements
and how to prepare a battery for
charging.
ASSEMBLING
YOUR
CHARGER
Included with your battery
charger
are two
cord wrap cleats for storage
of the clamp
cables.
To install, align the three tabs to corre-
spond with the three receptacles and push
until you hear a snap.
Wrap clamp cord after unplugging
the
power cord and store your charger in a
dry location.
PLUGGING
IT IN
Your charger requires a 120V AC
receptacle installed according to all
local codes and ordinances.
O
!
'N_I Ik
[_
('-Cord Wrap Cleat
USING AN EXTENSION CORD
The use of an extension
cord is not
recommended.
If you must use an
extension
cord, please
make sure
that you follow
these guidelines:
• Make sure that the pins on charger's
power
cord fit firmly
into the extension
cord, and that the extension
cord fits
firmly
into the receptacle.
• Check
that the extension
cord is
properly
wired and in good electrical
condition.
Make sure that the wire size is large
enough for its length and for the AC
ampere rating, as specified in the
chart below.
i_i_ii_ili _
_
Length
of Cord, in Feet
25
50
100
150
AWG* Size of Cord
18
16
12
10
*AWG=American WireGauge
5