DieHard 200.71224 소유자 매뉴얼 - 페이지 5

{카테고리_이름} DieHard 200.71224에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71224 16 페이지. Battery charger 15/2 amp fully automatic microprocessor controlled engine starter 100 amp
DieHard 200.71224에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

BEFORE USING YOUR BATTERY CHARGER

It is important to understand your charger's requirements. This section will tell you

about your charger's electrical requirements and how to prepare a battery for

charging.

ASSEMBLING YOUR CHARGER

Included with your battery charger are two

cord wrap cleats for storage of the clamp

cables.

To install, align the three tabs to corre-

spond with the three receptacles and push

until you hear a snap.

Wrap clamp cables after unplugging the

power cord and store your charger in a

dry location.

PLUGGING IT IN

Your charger requires a 120V AC

receptacle installed according to all

local codes and ordinances.

USING AN EXTENSION CORD

The use of an extension cord is not

recommended. If you must use an

extension cord, please make sure

that you follow these guidelines:

• Make sure that the pins on charger's

power cord fit firmly into the extension

cord, and that the extension cord fits

firmly into the receptacle.

• Check that the extension cord is

properly wired and in good electrical

condition.

• Make sure that the wire size is large

enough for its length and for the AC

ampere rating, as specified in the

chart below.

MINIMUM RECOMMENDED EXTENSION CORD

Length of Cord, in Feet

AWG* Size of Cord

*AWG=American Wire Gauge

Cord Wrap Cleat

100 150