Alpha Technologies AlphaNet DSM3 Series 설치 및 빠른 시작 설명서 - 페이지 4

{카테고리_이름} Alpha Technologies AlphaNet DSM3 Series에 대한 설치 및 빠른 시작 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Technologies AlphaNet DSM3 Series 6 페이지.

Installation Procedure, continued

5. If the Inverter Module is already equipped with a Communication Module,

remove it by loosening the two Phillips captive screws (Fig. 5, item A).

The following steps apply to both new installations or removal/replacement

of existing transponders:

6. Connect the 18-pin jumper (Fig. 6) supplied with the transponder into the

header on the back of the DSM3 Series circuit board (Fig. 7).

CAUTION!

Use of the incorrect jumper will cause damage to the

Transponder. Fig. 6 shows the correct 18-pin jumper.

7. Line up the 18-pin jumper with the header on the Inverter Module and connect

the unit to the Inverter Module (Fig. 8).

8. Fasten the Transponder to the Inverter Module by tightening the two captive

screws. It is recommended the screws be tightened alternately, a few turns

at a time so the transponder aligns in parallel to the Inverter Module.

Fig. 6, 18-pin Jumper

(Alpha p/n 540-286-19)

9. Reinstall the Inverter Module and reconnect the ribbon cable (see

Fig. 9). Make front panel connections (tamper, temperature sensor,

battery sense, etc.).

10. Verify the recording of the cable modem MAC address (RF MAC)

from the front of the unit, and the reporting of the MAC address

for network provisioning.

746-114-B1-001 Rev. A (02/2011)

Fig. 7, Connecting the Jumper

Fig. 5, Captive Screw Locations

Fig. 8, Connecting the

Communications Module to

the Inverter Module

Fig. 9, Inverter Moodule / Ribbon Cable Connection