DieHard 200.71231 소유자 매뉴얼 - 페이지 10
{카테고리_이름} DieHard 200.71231에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71231 16 페이지. Battery charger 50/15/2 amp manual engine starter with battery tester 225/125 amp
DieHard 200.71231에 대해서도 마찬가지입니다: 소유자 매뉴얼 (14 페이지)
페이지 인쇄
The "START" area of the ammeter indicates a high
rate of current being drawn by the battery. For ex-
ample, when cranking an engine, the needle will be at
the far right side of the =START" area since the starter
will be drawing up to 225 amps from the charger.
VOLTMETER:
To obtain an accurate reading of your battery's voltage
before you charge, use the voltmeter as follows:
1.
Set the timer to the OFF position, put the voltage
selector switch at 12 or 6 VOLT according to the
battery you are testing, and then connect the
charger as indicated in "Charging your battery in
the vehicle" on page 10. Charger does not have to
be plugged into an outlet.
2.
If a battery has recently been charged or in a
vehicle that has been run recently, you may want
to turn your headlights on for a few minutes before
you read the meter so as not to get a false reading
from a surface charge. Then shut lights off and
read the meter, by observing the color coding
(see below).
ALTERNATOR/GENERATOR
TEST
1.
Set the volt/amp selector switch to the OFF
position.
2.
Set the battery test switch to 6 or 12 volts.
3.
Set the timer switch to the OFF position.
4.
With the charger off, and the clamps properly
hooked up to the battery, start the engine and
while it is at a fast idle, read the charging system
meter. The battery Should be in a good state of
charge before doing this test.
5.
The voltmeter is divided into three color zones:
A. Green and Lighter Green - Charging system
is good.
B. Yellow - Alternator output is low.
C. Red - Charging system is bad.
NOTE: if meter needle points to Red or Yellow,
the charging system may have loose fan belts,
defective voltage regulator or alternator. Additional
tests may be required to find the exact cause.
Take the vehicle to a qualified service center.
BAD
SYSTEM •
6 VOLT BATTERY
BA'R'ERY
TEST
This testis based on the terminal voltage of the
battery. If the battery is installed in the vehicle, make
sure the engine and all accessories are turned off.
1.
Set the volt/amp selector switch to the OFF
position.
2.
Set the battery test switch to 6 VOLT for 6 volt
battedas or 12 VOLT for 12 volt batteries.
3.
Set the timer switch to the OFF position.
4.
Read lower 6 VOLT BATTERY section of meter
for 6 volt batteries and read upper 12 VOLT
BATTERY section for 12 volt batteries.
5.
Both 6 volt and 12 volt battery sections are divided
into three color zones:
A. Green - Good battery.
B. Yellow - Weak battery.
C.
Red - Bad battery.
NOTE: If the meter needle is in the Red or Yellow
area, the battery may only need charging. If, after
charging, the needle still indicates in the Red or
Yellow area, have the battery tested by a qualified
technician.
The meter needle may point to the Lighter Green
section of the meter if this test is done on a
recently charged battery or a battery from a
vehicle that has been run recently.
9