DieHard 200.71232 소유자 매뉴얼 - 페이지 5

{카테고리_이름} DieHard 200.71232에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71232 14 페이지. Automatic battery charger/engine starter
DieHard 200.71232에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

1. Using Your Battery Charger

Tap the other axle cap onto the opposite end of

the axle and place the axle assembly onto the

bottom of the charger. Place one end of the

bracket into slot, then place the axle assembly

under each bracket. Fasten the other side of the

brackets using the two 10-32 screws provided.

To attach

the handle:

Turn the charger right side up onto its foot and wheels.

Remove the two top screws from each side of the

charger and align with the screw holes on the handle.

Attach the handle using the same screws.

Plugging

it in

Electrical Shock Hazard

Be sure that power cord fits propedy into outlet.

If not, have a qualified technician install a proper

outlet. Never alter the AC cord or plug provided,

Improper connection can result in electrical shock,

Your charger should be grounded to reduce the

rlak of electrical shock.

Your charger is equipped with an electrical cord that

has an equipment grounding conductor and a ground-

ing plug designed to be used on a 120 volt circuit. The

plug must be plugged into an outlet that has been

properly installed and grounded in accordance with all

local codes and ordinances.