DieHard 200.713121 소유자 매뉴얼 - 페이지 13

{카테고리_이름} DieHard 200.713121에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.713121 16 페이지. 12/2/75 amp fully automatic battery charger engine starter
DieHard 200.713121에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Performance problems often result from little things that you can fix yourself. Please

read through this chart for a possible solution if a problem occurs.

No ammeter reading

Circuit breaker in

charger cycles on

and off with a

clicking sound in the

MANUAL setting.

Ammeter reads less

than selected

charge rate when

charging.

Charger makes a

loud buzz or hum.

Short start cycle

when cranking

engine.

Clamps not making good

connection.

2-amp charge rate.

No AC power reaching

charger.

Shorted battery clamps.

Shorted battery.

Charger leads reversed

on battery.

Extension cord too long

or gauge too small.

Battery has weak cell or

sulfated plate.

Battery is partially

charged.

Transformer laminations

vibrate

(buzz).

Shorted diode (hum).

Drawing more than 75

amps 7 seconds or less.

Failure to wait for 4

minutes (240 seconds)

between cranks.

Check for poor connection

at battery.

Make

sure clamps and posts are clean.

Battery may

not accept an AUTOMATIC

charge if severely

discharged.

Use MANUAL setting, see "Using

Your Battery Charger" on page 6.

Ammeter needle will indicate little activity at the

2-amp charge rate.

Check AC outlet and extension cords for loose

fitting plug.

Check for open fuse or circuit breaker

supplying AC outlet.

Separate the clamps. Circuit breaker cycles

when current draw is too high.

Check for worn cables and replace if needed.

Have a Sears technician test the battery.

Correct connections.

! Use shorter or heavier extension

cord.

Sulfated battery will eventually

take a

normal charge if left connected.

If the

battery will not take a charge, have it

tested by a Sears technician.

Continue charging

battery.

Continue charging. Buzz is not abnormal.

Have charger tested by qualified technician.

Crank time varies with the amount of current

drawn from the charger. If cranking draws

more than 75 amps, crank time may be less

than 7 seconds.

Wait 4 minutes before next crank.

If the above solutions

do not eliminate the problem,..call

ton-free from anywhere in the U.S.A.

1-000-SEARS-64

• (1400-732-7764)

7 AM to 4:30 PM CST Monday through Friday