DieHard 200.713151 소유자 매뉴얼 - 페이지 10

{카테고리_이름} DieHard 200.713151에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.713151 17 페이지. 15/2/125 amp fully automatic battery charger engine starter

NEGATIVE post first. Then remove the
lead from the POSITIVE post.
12. Clean and store the battery charger
in
a dry location.
POSITIVE
NEGATIVE
BATTERY
24", 6 GAUGE
CABLE
GROUNDED
POWER
Figure
B
OUTLET
Your battery charger can be used to jump start your car if the battery is low. Follow
these instructions
on how to use the ENGINE START feature.
1. Connect the charger to the battery
and vehicle as instructed
in the
"Charging
your battery" section on
page 8.
2. Setthe right hand SELECTOR
SWITCH on ENGINE START.
3. Crank the engine for no more than 5
seconds.
If it does not start, wait at
least 4 minutes
before cranking
again. In extreme cold or if the
battery is severely discharged,
charge the battery for about 5
minutes before cranking
the engine.
4. After the engine starts, unplug the
charger power cord from the AC
outlet. Then disconnect
the charger
from the battery.
IMPORTANT:
Do not try to start the
engine without a battery in it. You could
cause damage
to the electrical
system.
If the engine does turn over, but never
starts up, there is no problem with the
starting system,
but there is a problem
somewhere
else in the vehicle. STOP
cranking the engine until the other
problem
has been diagnosed
and
corrected.
1(}