DieHard 20071220 소유자 매뉴얼 - 페이지 8
{카테고리_이름} DieHard 20071220에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 20071220 10 페이지. Battery charger/maintainer 1.5 amp fully automatic float-mode monitoring
페이지 인쇄OPERATION INSTRUCTIONS
a)Set the 6 and 12 Volt selector switch to
match the voltage of the battery being
charged.
b)Connect
charger to a battery as out-
lined.
c) Plug AC power cord into 120 Volt, 60 Hz
receptacle.
d)The
amber
light indicates battery
is
being charged, the green light indicates
battery is fully charged, and the red light
indicates
trouble.
See more detailed
exPlanation below.
• When properly connected, the amber
LED indicator should illuminate, This
indicator will stay illuminated until the
battery voltage has reached approxi-
mately 14,4 Volt and the charge cur-
rent has decreased to 0.5 Amps. At
this point, the amber indicator turns
off and the green indicator turns on.
Also at this point, the internal voltage
reference of the charger will change
in order to maintain the battery volt-
age at 13.2 Volt. At this lower voltage,
charger current is typically a few mil-
liamperes (mA) (1 mA = 0.001 A).
Under this condition called maintain,
most batteries can be left charging
indefinitely.
If the battery
is loaded
with 0.5 Amps or greater white in the
maintain condition,
the charger will
change back to the normal charging
condition described above.
• Never leave the battery connected to
the charger while the charger is un-
plugged
from the AC outlet.
The
charger
draws a few milliamperes
(mA) from the battery and will eventu-
ally rundown the battery.
The Red LED indicates an overload
condition. Common causes are short-
ing of the battery clamps,
reverse-
polarity connection to a battery, and
charging a problem battery. An over-
load condition could also be caused
by charging two or more batteries in
parallel or charging a battery larger
than the size commonly used in a car
or truck. Once the charger goes into
the overload
state, it will not auto-
matically reset to the normal charge
state. One of the battery clamps must
first be disconnected from the battery
for at least 5 seconds.
CHARGING
TIMES
This charger
has a rated output of 1.5
Amps. This output will vary with the age
and condition ofthe battery being charged.
Approximate
Ampere Hour
Average Charge
Battery Capacity
Times in Hours
10
10-12.5
12
12-15+0
20
20-25,0