EPH Controls EMBER 사용 설명서 - 페이지 7

{카테고리_이름} EPH Controls EMBER에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EPH Controls EMBER 20 페이지.

1. Lower the cover on the front of the

RF programmer. Move the selector

switch to the 'RUN' position.

RUN

CLOCK

PROG

SET

2. On the RF programmer, press the

button for 5 seconds. Wireless

Connect will appear on the screen.

Figure (7-a)

3. On the RFR wireless room

thermostat or RFC wireless

cylinder thermostat, press the

'Code' button. This is located inside

the housing on the Printed Circuit

Board.

Figure (7-b)

4. On the RF programmer, the

available zones will begin to flash.

5. Press the

the zone you wish to connect the

thermostat to.

6. The wireless symbol

the screen.

7. The thermostat will count upwards

to the number of the zone that it is

paired with. When it reaches the

number of the zone that it is paired

with press the hand wheel on the

thermostat.

8. The RF programmer is now

operating in the wireless mode.

The temperature of the wireless

thermostat is now displayed on the

programmer.

9. Repeat this process for the second,

third and fourth zone if required.

Pairing thermostats

to your programmer

button for

appears on

Figure (7-a) 'Wireless Connection' screen

Reset button Code button

Figure (7-b) Printed Circuit Board

Figure (7-c) Zone screen