DieHard 200.71486 운영자 매뉴얼 - 페이지 4

{카테고리_이름} DieHard 200.71486에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71486 8 페이지. Jump starter and dc power source
DieHard 200.71486에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

CHARgINg THE INTERNAL bATTERY

IMPORTANT:

•

CHARgE IMMEDIATELY AfTER PURCHASE

•

KEEP fULLY CHARgED.

This Portable Power 750 comes with a sealed, non-spillable DieHard

maintenance-free lead-acid battery. This internal battery is specifically

designed to deliver high power jump-starting as well as repetitive deep

cycling performance.

To charge the Portable Power 750 internal battery:

3.1

Check the internal battery's charge level by pressing the switch marked

DISPLAY. The internal battery status LEDs will light.

NOTE: Internal battery status LEDs are most accurate when the Portable

Power 750 has been disconnected from all devices and charging sources

for 1 - 24 hours.

3.2

Using a proper extension cord, connect the cord to the charge plug and

then plug the cord into a properly wired and live 110Vac/60Hz wall outlet.

CAUTION: Operating the Portable Power 750 while the internal battery is

being charged may cause permanent damage to the unit.

3.3

While the Portable Power 750 is charging, the red "

illuminate. When the internal battery is fully charged, the green "FULL"

LED will illuminate. Complete charging may take up to 72 hours. The Por-

table Power 750 is then ready to use.

3.4

Once the battery is fully charged, the built-in charger automatically switch-

es to float-mode monitoring, which trickle charges the battery and keeps it

fully charged without overcharging.

The internal battery may also be charged while you drive using the male-

to-male accessory cable (available separately, see "Accessories and Re-

placement Parts" section of this manual). Insert one end of the accessory

cable into the 12V DC power outlet and the other end into the vehicle's

accessory outlet (lighter socket). Completely disconnect the accessory

cable when the engine is not running.

JUMP-STARTINg A vEHICLE ENgINE

Use in a well-ventilated area. Keep hands, hair, clothing and jewelry clear

of fan blades, belts, pulleys and other parts that may cause injury.

4.1

Turn ignition off before making cable connections.

4.2

Make sure the jump-start ON/OFF switch is in the OFF position.

4.3

Place the 750 on a flat, stable surface near the vehicle battery and away

from moving engine parts.

•

CHARgINg" LED will