DieHard 200.71988 운영자 매뉴얼 - 페이지 6

{카테고리_이름} DieHard 200.71988에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71988 16 페이지. Jump starter/dc power source air compressor, inflator and ac power
DieHard 200.71988에 대해서도 마찬가지입니다: 운영자 매뉴얼 (15 페이지)

페이지 인쇄

CHARgINg THE INTERNAL bATTERY

IMPORTANT:

•

CHARgE IMMEDIATELY AfTER PURCHASE

•

KEEP fULLY CHARgED.

This Portable Power 1150 comes with a sealed, non-spillable DieHard

maintenance-free lead-acid battery. This internal battery is specifically

designed to deliver high power jump-starting as well as repetitive deep

cycling performance.

To charge the Portable Power 1150's internal battery:

3.1

Check the internal battery's charge level by pressing the switch marked

DISPLAY. The Digital Display will show the battery's percentage. Charge if

under 100%

NOTE: Internal battery's percentage is most accurate when the Portable

Power 1150 has been disconnected from all devices and charging sources

for 1 - 24 hours.

3.2

To charge, plug the (external) wall charger cord into the socket on the

back of the 1150. Then, plug the wall charger into a 120V AC source.

CAUTION: Operating the Portable Power 1150 while the internal battery is

being charged may cause permanent damage to the unit.

3.3

While the 1150 is charging, the battery's percentage of charge will be

displayed. When the internal battery is fully charged, the display will show

100. Complete charging may take up to 48 hours. The 1150 is then ready

to use.

3.4

Once the battery is fully charged, the internal charging circuitry automati-

cally switches to float-mode monitoring, which keeps the battery fully

charged without overcharging.

The internal battery may also be charged while you drive using the male-

to-male accessory cable (available separately, see "Accessories and Re-

placement Parts" section of this manual). Insert one end of the accessory

cable into the 12V DC power outlet and the other end into the vehicle's

accessory outlet (lighter socket). Completely disconnect the accessory

cable when the engine is not running.

•