DieHard Portable Power 950 운영자 매뉴얼 - 페이지 5

{카테고리_이름} DieHard Portable Power 950에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard Portable Power 950 9 페이지. 12v dc power source and jump starter
DieHard Portable Power 950에 대해서도 마찬가지입니다: 운영자 매뉴얼 (9 페이지), 소유자 매뉴얼 (9 페이지), 운영자 매뉴얼 (13 페이지), 운영자 매뉴얼 (7 페이지)

페이지 인쇄

3.1

Check the internal battery's charge level by pressing the switch marked

DISPLAY. The Digital Display will show the battery's percentage. Charge if

under 100%

NOTE: Internal battery's percentage is most accurate when the Portable

Power 950 has been disconnected from all devices and charging sources

for 1 - 24 hours.

3.2

To charge, plug the (external) wall charger cord into the socket on the

back of the 950. Then, plug the wall charger into a 120V AC source.

CAUTION: Operating the Portable Power 950 while the internal battery is

being charged may cause permanent damage to the unit.

3.3

While the 950 is charging, the battery's percentage of charge will be

displayed. When the internal battery is fully charged, the display will show

100. Complete charging may take up to 48 hours. The 950 is then ready

to use.

3.4

Once the battery is fully charged, the internal charging circuitry automati-

cally switches to float-mode monitoring, which keeps the battery fully

charged without overcharging.

The internal battery may also be charged while you drive using the male-

to-male accessory cable (available separately, see "Accessories and Re-

placement Parts" section of this manual). Insert one end of the accessory

cable into the 12V DC power outlet and the other end into the vehicle's

accessory outlet (lighter socket). Completely disconnect the accessory

cable when the engine is not running.

JUMP-STARTINg A VEHICLE ENgINE

Use in a well-ventilated area. Keep hands, hair, clothing and jewelry clear

of fan blades, belts, pulleys and other parts that may cause injury.

4.1

Turn ignition off before making cable connections.

4.2

Place the 950 on a flat, stable surface near the vehicle battery and away

from moving engine parts.

4.3

Connect the red clamp to the positive (+) terminal of the vehicle battery.

NOTE: In the rare case of jump-starting a vehicle that has a positive-

grounded vehicle electrical system, connect the black clamp to the

negative terminal of the vehicle battery. Then connect the red clamp to

an unpainted and unmoving part of the vehicle chassis or engine block. If

you are unsure of the nature of the vehicle's electrical grounding system,

check the owner's manual of the vehicle or call the Customer Technical

Assistance number: 1-800-SEARS-64.

4.4

Connect the black clamp to an unpainted and unmoving part of the vehicle

chassis or engine block. Do not connect to the carburetor, fuel lines or

sheet-metal body parts. The Digital Display displays the vehicle's voltage.

•