DieHard 200.7123 소유자 매뉴얼 - 페이지 5

{카테고리_이름} DieHard 200.7123에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.7123 14 페이지. Batiery charger 40/2 amp manual 200 amp engine starter

Before Using Your Battery Charger

It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground

and connect the power cord, and prepare to charge a battery.

Assembling

your charger

It is important to fully assemble your charger before use.

Follow these instructions for easy assembly.

PARTS:

Two 10-32 thread cutting

screws

Two 1/4-20 thread cutting

screws

Two wheels

One axle

Two axle caps

Two axle brackets

One handle

One mounting foot

TOOLS NEEDED:

3/8" wrench

(for mounting foot)

5/16" wrench

(for wheels)

Hammer

Phillips screwdriver

To attach the axle assembly:

Remove charger from packing materials and place

upside down on a flat surface. Attach mounting

foot and secure with the two 1/4-20 thread cutting

screws.

Hold axle upright on floor or work surface. Then,

using a hammer, tap one of the plastic hubs onto

the top end of the axle. Be sure to tap the hub on

straight. Slide both wheels onto the axle with the

hubs facing inward.

continued on next page