Diehl Metering AURIGA DN 20 사용자 설명서 - 페이지 7
{카테고리_이름} Diehl Metering AURIGA DN 20에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diehl Metering AURIGA DN 20 10 페이지.
AURIGA DN15/20
2.2.2
PLACE OF INSTALLATION
2.2.3
INSTALLATION RECOMMENDATIONS
fig.6
fig.7
fig.8
7
Caution: Make sure that the direction of
the water flow matches the direction of
the arrows located on the meter's body.
The metered water must be free from
gas.
Install AURIGA at a low point of a pipe to
prevent the formation of air pockets.
No straight length required either before
or after the meter (U0 / D0 approved).
The body of the meter incorporates
2 nozzles, each with a standard
connection thread. The gaskets that
form the seal between the meter
and the connectors are not included.
Caution: Do not use Teflon tape or
threadlocker.
To prevent the meter from rotating
during tightening, thus damaging
the gaskets, the use of a spanner on
each end of the inlet and outlet
nozzle is recommended.
Do not exceed the maximum
tightening torque of 3 m.kg. or 30
Nm.
09/2020