Axis Electronics NANO-600G10 사용자 설명서 - 페이지 14

{카테고리_이름} Axis Electronics NANO-600G10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis Electronics NANO-600G10 17 페이지. Electronic weighing scale

With the weight still on the pan, the

display will now show the weight that is

calibrated. Check calibration to ensure the

scale is reading correct

INTERNAL SERVICE CALIBRATION

7.2

Internal calibration also referred as service calibration requires

opening the machine and changing the jumpers. It is advisable to

do this step only if you have required assistance or the service

personnel assisting you to do this.

STEP

Open the 4 screws from the bottom of the

machine and change the calibration

jumper marked CAL. Now place back the

cover, ABS pan and the SS pan and switch

on the machine. Make sure there is

nothing kept on the weighing pan. At this

moment do not put back the screws,

simply place the cover on the machine.

To start calibration turn the scale off and

then turn it on. During the count down,

press and hold down the Zero button (do

not release until the display shows "CAL"

Make sure there is no weight on the pan.

Press Zero / Enter key and the display

shows "noLoAd" momentarily and shows

the counts at zero level.

PROCEDURE

NANO Series Precision Balance

DISPLAY