Acculaim Dyna Drum HO 사용자 설명서 - 페이지 13

{카테고리_이름} Acculaim Dyna Drum HO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acculaim Dyna Drum HO 20 페이지.

페이지 인쇄

Determining solo behavior

You can choose how the fixture should behave when it is running solo, either because an

external control input is not being used at all or because a connection has been temporarily

lost. There are three solo behavior choices:

• Go dark (blind) - In this mode, when no external control is present, the emitter output will

be extinguished.

• Show internal color/chase - In this mode, when no external control is present, the fixture

can be made to show a pre-programmed color or chase (not all models). Further details

about creating static color mixes and programming chases are given in the next two

sections.

• Show last - In this mode, when no external control is present, the emitter output will

remain as per the last received instruction.

To determine the solo behavior

1 Enter the user menu (see page 8).

2 Select the SoLo menu item. The currently set solo behavior mode will flash on the display.

3 Use the

and

• bLnd - blanks the emitters when no external control is present.

• IntL - displays either the static color (or white intensity on WW models) or color chase

(on color models only) that has been internally programmed (see the next two sections

for details on programming colors and chases).

Note: On color models, when a static color is programmed, it will take precedence over a

programmed chase. You will need to ensure that the static color option is at zero in order for

a chase to be shown when the IntL mode is chosen and no external input is present.

• LASt - continues to show the last received external instruction.

4 Press

ENTER

to save.

Programming and displaying a chase

Note: Chases are only possible on Dyna Drum HO color models.

The Dyna Drum HO fixture can be programmed to scroll through the full range of colors

at a chosen speed and fade time. In order to view the chase, you will need to ensure the

following:

• The SoLo behavior mode is set to the IntL option.

• The static color option (CoLo) is set to zero output.

• There is no external DMX control input.

To program a chase

1 Enter the user menu (see page 8).

2 Select the ProG menu item. The current speed setting will be shown (e.g. S 1).

3 Use the

and

. The current fade setting will be shown (e.g. F 1).

4 Press

ENTER

5 Use the

and

Note: The fade time is limited by the speed setting - it' s value cannot exceed that for the speed.

6 Press

ENTER

to save.

The chase will be shown once the fixture exits from the menu, providing the conditions

mentioned above are met.

buttons to choose the required solo behavior mode:

buttons to set the required speed between 0 and 240 (in seconds).

buttons to set the required fade time between 0 and 240 (in seconds).