Olympus C 4000 - CAMEDIA Zoom Digital Camera 빠른 시작 매뉴얼

{카테고리_이름} Olympus C 4000 - CAMEDIA Zoom Digital Camera에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus C 4000 - CAMEDIA Zoom Digital Camera 2 페이지. Software installation guide (160 kb)
Olympus C 4000 - CAMEDIA Zoom Digital Camera에 대해서도 마찬가지입니다: 자주 묻는 질문 (7 페이지), 소프트웨어 설치 매뉴얼 (2 페이지)

페이지 인쇄

Olympus C 4000 - CAMEDIA Zoom Digital Camera 빠른 시작 매뉴얼

QuickStart Guide

C-4000 ZOOM

It is strongly recommended

START

that you follow these step-

by-step numbered

instructions to set up and

quickly begin using your

new C-4000 Zoom digital

camera.

For more detailed instructions on advanced features, please refer

to the printed Basic Manual included in your package, or the

Reference Manual on the CD-ROM.

PREPARE THE CAMERA FOR USE

Before you begin using your Olympus C-4000 Zoom Digital Camera...

Load the batteries

The CR-V3 lithium batteries included with your C-4000 Zoom

are much more powerful than standard AA alkaline batteries.

Please note that they are not rechargeable.

Load the two CR-V3 lithium batteries. Note they can only be

inserted with the indentations facing each other. The contact terminals

must be inserted first, as shown at right. Never force battery insertion.

When loading CR-V3 batteries ignore the illustration on the camera body.

If you are loading four AA type batteries into the compartment, load them as

indicated in the illustration on the camera body. Close the cover and lock the

battery compartment door.

TIP: For best results, Olympus strongly recommends using four AA nickel metal

hydride (NiMH) rechargeable batteries. An optional Olympus AC adapter also

is available, and is recommended when downloading images to ensure a consistent

power supply.

See the C-4000 Zoom Basic Manual for more information on battery use.

Insert the SmartMedia

The SmartMedia card is where the camera stores your pictures. The pictures

you take remain on the SmartMedia card even when the camera is turned off

and/or the batteries are removed.

TURNING ON THE CAMERA

The camera Power/Mode dial is used to select the various operation modes.

Turn the camera ON

• Squeeze the tabs on the sides of the lens cap to remove it.

• Turn the Power/Mode dial counter clock-wise to the "P" position.The monitor will activate briefly,

and then turn off.

TIP: To maximize battery life, the C-4000 Zoom features a power saving mode in which the camera enters a sleep

mode after approximately three (3) minutes of non-use. Press the shutter button or zoom lever to wake up the camera.

Set the Date and Time

Although this is not required, it is recommended that you set the date and time. This affects the way

image files are named, and each picture will be recorded with this information.

• Set the mode dial to "P" and press

• Press

on the arrow pad to select MODE MENU.

• To access the Date/Time menu, press

• Press

five (5) times to select

• Use the

keys to select the desired date format (usually M, D, Y).

• Press

to proceed to the next field. Adjust the date and time in the appropriate fields using the

keys. Repeat the process until all date/time fields have been set.

Note: Time is entered using the 24-hour format.

• Press

twice to set the date and time and exit the menu.

Camera Diagram and Controls

Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.

Diopter adjustment dial

Lens cap

and retainer

string

Connector cover

5-pin external

flash socket

VT452702

HERE

™

Card

(OPTIONAL)

. The monitor turns on and the top menu appears.

three (3) times to scroll to the SET tab. Now press

, and then press

Shutter button

Mode dial

Flash

Zoom lever

Strap eyelet

DC-IN jack

VIDEO-OUT jack

USB connector

Lens

Need more help?

visit http://support.olympusamerica.com

for online automated help

UNPACKING THE BOX CONTENTS

Gather your C-4000 Zoom and all the parts as shown in the illustrations. You'll need these to complete the steps for the

camera set-up procedures that follow.

C-4000 Zoom

Strap

with lens cap

retainer string

The following items are also included in the C-4000 Zoom package: Video cable, SmartMedia card instructions, Basic Manual,

warranty card, registration card, safety precautions booklet, and SmartMedia write-protect adhesive seals.

First, make sure the camera is OFF. Open the card cover door. Note the diagram on the inside of the

door. Match the orientation of the SmartMedia card to the diagram, and slide the card into the spring-

loaded slot as far as it will go. Close the cover until it locks into place; you will feel it snap closed.

Avoid opening the card cover, removing the SmartMedia card, or removing the

batteries while the camera is ON. Doing so could damage all pictures stored on the

SmartMedia card.

Battery compartment lock

To remove a SmartMedia card, push it into the camera, and then release it. The card partially ejects

and can now be removed.

Attach the carrying strap and lens cap retainer string

We recommend that you attach the strap and lens cap retainer string at this time to make the

camera easier to handle and prevent loss of the lens cap. Attach the strap as illustrated.

AF target mark

Self-timer lamp

Note: Depending on

the camera settings,

not all indicators

will be displayed

Lens cap

Two CR-V3

CAMEDIA

lithium batteries

Master 4.0 CD-ROM

Macro/Spot button

Flash mode button

Print button

Viewfinder

Erase button

Monitor

Tripod socket

Camera Settings in Shooting Mode as shown in Monitor

Flash stand-by/Camera movement warning

Flash charge

Aperture

value

Shooting mode

Battery check

F2.8 1/800

Green lamp

AEL

Flash mode

Memory gauge

2288x1712

Number of storable

still pictures

Spot metering

Seconds remaining

Macro mode

Super macro mode

Camera Settings in Playback Mode as shown in Monitor

Battery check

X10

SIZE: 1984X1488

ISO400

02.06.10 12:30

FILE: 100-0016

Olympus America, Inc.

Two Corporate Center Drive

Melville, NY 11747-3157

USB cable

16MB SmartMedia card

(beige color)

with static-free case

and labels

(OPTIONAL)

Arrow pad

OK/Menu button

Manual focus button

Monitor button

Card access lamp

Custom button

Protect button

Rotation button

Battery compartment lock

Battery compartment cover

Shutter speed

Exposure compensation

Exposure differential

0.0

AE lock/AE memory

Self-timer

Drive mode

ISO

White balance

Record mode

Number of pixels

AF Target mark

Print reserve

Number of prints

Protect

Record mode

Number of pixels

Exposure compensation

White balance

ISO

Date and time

File number

Printed in Japan