Olympus Camedia D-390 빠른 시작 매뉴얼

{카테고리_이름} Olympus Camedia D-390에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus Camedia D-390 2 페이지. D-390 quick start guide - spanish (312kb)
Olympus Camedia D-390에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), (빠른 시작 가이드 (2 페이지), (빠른 시작 가이드 (2 페이지)

Olympus Camedia D-390 빠른 시작 매뉴얼

QuickStart Guide

D-390 / C-150
START HERE
It is strongly recommended that you follow these
step-by-step numbered instructions to set up and
quickly begin using your new Digital Camera.
For more detailed instructions on advanced features, please refer
to the printed Basic Manual included in your package, or the
Reference Manual on the CD-ROM.
PREPARE THE CAMERA FOR USE
Before you begin using your Olympus digital camera...
a.
Loading batteries
• Slide the battery compartment cover in the direction of
(the direction indicated by the
and lift it up in the direction of
• Insert batteries in the direction shown in the illustration.
There is a mark on the bottom of the
camera showing the correct way to insert
batteries.

TURNING ON THE CAMERA

All you need to do is slide the lens barrier open or closed to turn the camera ON or OFF.
a.
Turn the camera ON
(SHOOTING MODE)
• Open the lens barrier.
• Close the lens barrier to turn the camera off.
Power on
Lens barrier
TIP: To
maximize battery life, this digital camera features a power saving mode in which the camera enters a sleep mode after
approximately three (3) minutes of non-use. Press the shutter button to wake up the camera.
b.
Set the Date and Time
Although this is not required, it is recommended that you set the date and time. This affects the way image
file names are created, and will conveniently include this information with each picture. The date and time
can also be set when the camera is in the playback mode.
• Open the lens barrier fully until it clicks.
• Press
to display the menu.
• Press
to select MODE MENU.
• Press
three times to select SETUP.
• Press
once, and then
twice to highlight
• Use
to select the date format.
• Adjust the date and time in the appropriate fields by using
the proper value. Repeat this step until all date/time fields have been set.
Note: Time is entered using the 24-hour format.
• Press
twice to set the date and time and exit the menu.
c.
Camera Diagram and Controls
Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.
Strap eyelet
Card cover
Shutter button
USB
USB connector
Lens barrier
VT450901
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville,
NY 11747-3157, U.S.A.
http://support.olympusamerica.com/
A
mark on the cover),
B
.
B
Power off
(OPTIONAL)
, and then press
once.
to select the field, and
Flash
VIDEO OUT jack
Self-timer lamp
Lens
OLYMPUS OPTICAL CO. (EUROPA) GMBH
Wendenstrasse 14-18,
20097 Hamburg, Germany
http://www.olympus-europa.com

UNPACKING THE BOX CONTENTS

Gather your digital camera and the parts as shown in the illustration. You'll need these to complete the steps for the
camera set-up procedures that follow.
Strap
Digital camera
The following items are also included in this package: Basic Manual, video cable, warranty card, registration card (not
pvovided in some areas), and safety precautions booklet.
• Close the battery compartment cover so that it pushes the batteries down inside. While pressing
the
mark, slide the cover in the opposite direction of
TIP:
An optional Olympus E-7AC AC adapter is available, and is recommended when downloading images to ensure a
consistent power supply. See the Basic Manual for more information.
b.
Insert the xD-Picture Card
The xD-Picture Card is where the camera stores your pictures and is available in a variety
of memory capacities. The pictures you take with the camera remain on the xD-Picture
Card even when the camera is turned off and/or the batteries are removed.
A
• Insert the xD-Picture Card into the spring-loaded card slot as shown
in the illustration. Push the card fully into the slot. The card will lock
into place when fully inserted.
• To remove, push down on the xD-Picture Card. The card will pop up.
Pull to remove.
• Close the card cover.
Confirm you have installed the batteries and xD-Picture Card properly by
pressing
. The "No Picture" message should be displayed in the monitor.
Turn the camera off by pressing
c.
Attach the strap
Attach the strap as illustrated to make the camera easier to handle.
to set
VIDEO OUT
DC IN 3.4V
DC-IN jack (3.4V)
Connector cover
AA (R6) alkaline
CAMEDIA
batteries (x2)
Master CD-ROM
again.
(OPTIONAL)
Orange lamp
AF target mark
Green lamp
Viewfinder
Monitor
Monitor button (QUICK VIEW
Playback button (
)
CR-V3X1
Tripod socket
Battery compartment cover
Camera Settings in Shooting Mode as shown in Monitor
Shooting mode
Exposure compensation
Battery check
P
Macro
Flash mode
Self-timer
(still pictures only)
Record mode
HQ 1600 x 1200
Number of storable still pictures/
seconds remaining for movies
Resolution (number of pixels)
Camera Settings in Playback Mode as shown in Monitor
Battery check
x 10
SIZE: 1600x1200
Date and time
'03.09.12 12:30
FILE: 100–0020
Note:
• Depending on the camera settings, not all indicators
will be displayed.
http://www.olympus.com/
USB cable
xD-Picture Card
(grey color)
.
Arrow pad
OK/Menu button
)
or
LR6X2
+2.0
Spot metering mode
White balance
AF target mark
Print reserveation
Number of prints
Protect
HQ
Record mode
Number pixels
+ 2.0
Exposure compensation
White balance
File number, Frame number,
Playing time/
Total recording time
Printed in China