Dielectric TLP-16 사용 설명서 - 페이지 4

{카테고리_이름} Dielectric TLP-16에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dielectric TLP-16 12 페이지.

Uncrating

Prior to opening any crate(s) or removing strapping from skids, inspect for shipping

damage. Notify the carrier immediately of any observed damage to the crate.

Note: TLP-8: The antenna single section is shipped under pressure and should remain so

until installation.

TLP-16,-24,-32: The two, three, or four antenna sections and feed lines are

shipped under pressure and should remain so until installation.

Open each crate and verify contents against packing list. If any parts are missing notify

Dielectric Communications immediately. Inspect contents for possible shipping damage.

Note: If any parts are found damaged, promptly notify the carrier. Shipping crates may

be used to return damaged parts.

Antenna Sections

Antenna sections are crated individually fully assembled, with hardware and O-rings.

Transmission Line, Power Divider & Feed Lines

Transmission lines may be crated with one or more sections per box. Feed lines are coiled

in a separate crate.

Power dividers and feed lines (TLP-16,-24,-32) were match marked so that the antenna

system will perform as tuned by the factory.

Where applicable, elbows and transmission line(s) for an elbow complex may be matched

marked.

Note: Discoloration on transmission line exterior surface is normal and was caused by

handling and exposure to the elements during tuning.

Mounts

Mounts may be crated on a pallet or in a box. Verify quantities and check for damage

prior to removal.