AccuLine 40-6610 사용 설명서 - 페이지 9

{카테고리_이름} AccuLine 40-6610에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuLine 40-6610 15 페이지. Self-leveling 3-line laser level

40-6600_6610

Note: Check whether the unit is in locked position before it is put into

carrying case. If not, during movement the unit will give an alarm

as reminder, with automatic laser beam flashing at the same time.

Tripod/Wall Mount Bracket

1. The tripod/wall mount bracket can be used at

any position and height.

2. There are three screw eyes on the holder, through

which you can fix the holder on the wall by three

screws of 0.157" - 0.197" (4-5mm) diameter.

3. The holder can also be connected with elevating

staff or tripod by its bottom thread.

4. The holder can also be positioned on any level surface.

5. The holder must be tilted less than 3.5°.

8. Self-Check and Calibration

Horizontal Accuracy Self-Check

1. Set up two survey-

staffs that are 16 ft.

(5m) away from each

other.

2. Set the bracket on the

tripod or elevating

pole, put the unit into

the bracket, and then

place the setup at the center between the two survey-staffs.

3. Switch on front horizontal beam button H and front vertical

beam button V1. Have their cross located on staff A and note

down the value of a1.

4/22/05

4:56 PM

Page 9

Survey-staff B

Survey-staff A