Olympus DS 150 운영 매뉴얼 - 페이지 8

{카테고리_이름} Olympus DS 150에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus DS 150 18 페이지. Olympus microcassette recorder user manual

페이지 인쇄

Follow the procedure below to set the user ID number:

ERASE SP DICT

In the Stop mode, press and hold the MENU switch

played on the LCD panel

twice the MENU switch's up/down control in the down direction to display [ID AAA] (when in the ini-

tial setting). The cursor will start blinking at the first digit's position.

Turn the MENU switch's up/down control in the up direction to change the character displayed: [A]

[C] ...... [X]

[B]

[Y]

[Z]

[0]

When the desired character is displayed, press the MENU switch to set it. The blinking cursor

moves to the next position.

Follow the same procedure to set each character. When ID setting is complete, press the MENU

switch to enter the Format mode. (See page 31.)

Pressing the STOP button instead of the MENU switch after ID setting ends menu setting and

restores the Stop mode.

If the Format mode is entered in

but you do not need to format the built-in memory, press the

STOP button. This ends menu setting and restores the Stop mode.

ERASE SP DICT

INDEX/

FOLDER

for at least 2 seconds. The menu will be dis-

...... [7]

[B] ......

[1]

[2]

[8]

[9]

[A]

BASIC OPERATION

RECORDING

INDEX/

FOLDER

REC STOP

Remaining

Message No.

memory time

Make sure [NEW], memory remaining time, and the message number are displayed on the LCD

panel. Ensure there is sufficient remaining time available for your message and select the folder

([A] or [B]), microphone sensitivity ([DICT] or [CONF]) and recording mode ([SP] and [LP]).

To change the folder, press the INDEX/FOLDER button

recording in the other folder. To change the microphone sensitivity or recording mode, use the

menu (see page 29 for the change procedure).

Press the REC button

to start recording. The LED

Press the STOP button to stop recording and enter the Stop mode.

You can monitor what is being recorded through an earphone plugged into the EAR jack

(recording monitor).

If [NEW] is not displayed when you press the REC button, insertion recording will start. This over-

writes the previous recording so be sure you always check the display before pressing the REC

button.

If [FULL] is displayed on the LCD panel, additional recording is not possible. In this case, erase

unnecessary messages to free up more memory. If there are any messages that you want to pre-

serve, transfer the voice data to a PC using the PC transfer kit (available as a standard or optional

accessory).

Do not connect or disconnect the AC adapter plug during recording. Always enter the Stop mode

before plugging or unplugging the adapter. Otherwise, you will not be able to play back the mes-

sage being recorded.

The recording monitor volume cannot be adjusted.

Always use the SP mode if you want to record high-quality voice data suitable for transfer to a PC

for use in voice recognition operations.

(For more about voice recognition, see page 33.)

to move to the position after the last

lights and recording starts.