Olympus VN-801PC 사용 설명서 - 페이지 3

{카테고리_이름} Olympus VN-801PC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus VN-801PC 19 페이지. Vn-801pc instrucciones (espa?ol)
Olympus VN-801PC에 대해서도 마찬가지입니다: (스페인어) 사용 설명서 (19 페이지)

페이지 인쇄

Battery indicator:

When [

] appears on the display, replace the batteries as soon as possible. When the batteries are

too weak, [s] and [Battery Low] appears on the display and the recorder shuts down.

• Remove the batteries if you are not going to use the recorder for an extended period of time.

• When changing batteries, AAA alkaline batteries or Olympus Ni-MH rechargeable batteries are

recommended.

h Turning on/off the power

Power save mode

If the recorder is stopped/not used for over 5 minutes after it is turned on, it goes into standby

(power-save) mode, and the display shuts off.

• To exit standby mode and turn on the display, press any button.

h HOLD

Notes:

• If you press any button in HOLD mode, the clock display ﬂ ashes for 2 seconds, but it will not

operate the recorder.

• If HOLD is applied during playback (recording), operation is disabled with the playback (recording)

state unchanged (When playback has ended and the recording has ended due to the remaining

memory being used up, it will stop).

h Setting time and date [Time & Date]

If you set the time and date beforehand, the information when the file is recorded is automatically

stored for each file. Setting the time and date beforehand enables easier file management.

When you install batteries for the first time or each time you replace the batteries, the

"Hour" indication will flash.

2 Insert size-AAA alkaline battery,

observing the correct = and -

polarities.

3 Close the battery cover completely

by pressing to the direction A, then

sliding to the direction B.

Turning on the power:

While the recorder is turned off, slide the

POWER/HOLD switch in the direction indicated

by the arrow.

• The display will turn on, and the power will be turned

on.

Turning off the power:

Slide the POWER/HOLD switch in the direction

indicated by the arrow for 1 seconds or longer.

• The display shuts oﬀ , and the power will be turned

oﬀ .

• The resume function remembers the stop position

before the power is turned oﬀ .

Set the recorder to HOLD mode (A):

Slide the POWER/HOLD switch to the HOLD

position.

• After [Hold] appears on the display, the recorder is set

to HOLD mode.

Exit HOLD mode (B):

Slide the POWER/HOLD switch to the C posi-

tion.