Olympus BH-2 BHS 완전한 분해, 청소 및 재조립 - 페이지 21

{카테고리_이름} Olympus BH-2 BHS에 대한 완전한 분해, 청소 및 재조립을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH-2 BHS 23 페이지. Sliding focus block

Figure 64 – Apply grease to both ends of the guide block

Set the Guide Rails into the Greased Guide

Place one of the guide rails into one of the inside

corners of the side groove of the guide block (see Figure

65) and press the guide rail down firmly at the ends to

thoroughly embed it into the grease (see Figure 66).

Figure 65 – Place first guide rail into the guide block

Figure 66 – Set the first guide rail into the grease

Place the second guide rail into the other inside corner

of the side groove of the guide block (see Figure 67) and

press the guide rail down firmly at the ends to

thoroughly embed it into the grease (see Figure 68).

Complete Teardown, Cleaning, and Reassembly of the Olympus BH‐2 Sliding Focus Block

Figure 67 – Place second guide rail into the guide block

Figure 68 – Set the second guide rail into the grease

Clean Grease after Reinstalling the Guide Rails

After the guide rails have both been placed in the guide

block and pressed down firmly into the grease, any

visible traces of the grease should then be removed

from the guide block and guide rails. The best way to

do this is to use dry cotton swabs to scrub the grease

away (see Figure 69).

Figure 69 – Scrub any visible grease from the guide rails

The fresh grease should come off easily with dry cotton

swabs. Do not use any solvent here, as the solvent may

run under the guide rails and foul the grease holding

them in place. Carefully work from the inside out when

Revision 2

Page 21 of 23