Olympus BH2-5RE 완전한 분해, 청소 및 재조립 - 페이지 7
{카테고리_이름} Olympus BH2-5RE에 대한 완전한 분해, 청소 및 재조립을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2-5RE 18 페이지. Modular revolving nosepiece
페이지 인쇄
Figure 4 – Remove four screws securing the dovetail slide
Figure 5 – Remove the loose dovetail slide
Remove the Cover from the Turret Assembly
Use a suitable JIS screwdriver to remove the three
M2X3 countersink screws securing the protective cover
onto the stationary base (see
protective cover (see
Figure
Figure 6 – Remove screws securing the cover in place
Complete Teardown, Cleaning, and Reassembly of the Olympus BH2-5RE Modular Revolving Nosepiece
Figure
6) and remove the
7).
Figure 7 – Remove the protective cover
Figure 8 – The turret assembly (without cover)
Remove Lock Ring for Pivot-Adjustment Screw
The slotted lock ring for the pivot-adjustment screw
(see
Figure
8)
can be difficult to remove unless the
proper tool is used. Do not attempt to remove the
slotted lock ring from the pivot-adjustment screw
unless you have access to such a tool, since the slot in
the lock ring will likely be damaged if you use an
improper tool, making removal of the lock ring much
1
more difficult
.
A suitable tool for this task can be easily made by filing
or grinding a relief notch for the pivot-adjustment screw
in the center of the blade of a large slotted screwdriver,
as shown in
Figure
9. Note that if you decide to make
such a tool, be sure that the tip of the screwdriver you
select has a blade width matching the outer diameter of
the slotted lock ring, and that the thickness of the blade
is such that it will seat fully into the slot of the slotted
lock ring.
1
Don't even think about using a pair of needle-nose pliers to loosen
the slotted lock ring. It will end badly if you do this. Don't ask me
how I know this.
Page 7 of 18
Revision 3