Olympus BH2-CH Substage 어셈블리 - 페이지 13

{카테고리_이름} Olympus BH2-CH Substage에 대한 어셈블리을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2-CH Substage 26 페이지.

페이지 인쇄

Figure 34 – Remove centering plunger from the bore

Reassemble the Centering Plunger

Use a cotton swab wetted with a suitable solvent (e.g.,

acetone) to clean any old grease from the plunger and

spring. Also clean the bore in the condenser slide, the

face of the dovetail slide, and the bearing surfaces on

the face and bevels of the dovetail slide (see

Figure 35 – Clean grease from bore and dovetail slide

Apply fresh grease to the centering-plunger bore in the

condenser slide (see

Figure

Figure 36 – Apply grease to the centering-plunger bore

Insert the centering plunger, with attached c-clip, into

the centering-plunger bore in the face of the dovetail

slide (see

Figure

37).

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

36).

Figure 37 – Reinstall plunger and c-clip into bore

Insert the plunger-extension spring into the centering-

plunger bore in the face of the dovetail slide (see

38).

35).

Figure 38 – Reinstall plunger-extension spring into bore

Compress the extension spring and reinstall the

plunger-retaining screw into the bore of the dovetail

slide, to retain the extension spring and centering

plunger (see

Figure 39 – Reinstall the plunger-retaining screw

Use a suitable slotted screwdriver to tighten the

plunger-retaining screw such that the head of the screw

is slightly recessed relative to the face of the dovetail

slide (see

Figure 40

screw from interfering with the mounting of the plastic

condenser-height rack. Wipe off any grease pushed out

by the plunger.

Figure

39).

and

Figure

41). This will prevent the

Revision 1

Figure

Page 13 of 26