Olympus BHTU 완전한 분해, 청소 및 재조립 - 페이지 15
{카테고리_이름} Olympus BHTU에 대한 완전한 분해, 청소 및 재조립을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BHTU 19 페이지. Reverse nosepiece
Olympus BHTU에 대해서도 마찬가지입니다: 사용 설명서 (22 페이지)
페이지 인쇄Apply Grease to the Mechanical Detents
Apply fresh grease (item 8 of
mechanical detent notches in the revolving turret (see
Figure
41).
Be careful that you do not get grease
anywhere else.
Figure 41 – Apply grease to the five detent notches
Reinstall the Protective Cover
Place the protective cover into position on the back side
of the turret assembly, lining up the three holes in the
protective cover with the tapped holes in the stationary
base (see
Figure
42).
Figure 42 – Place cover in position on the turret assembly
Use a suitable JIS screwdriver to reinstall three M2X3
countersink screws to secure the protective cover onto
the stationary base (see
Complete Teardown, Cleaning, and Reassembly of the Olympus BHSU/BHTU Reverse Nosepiece Assembly
Appendix
1) to the five
Figure
43).
Figure 43 – Secure protective cover using three screws
Reinstall the Knurled-Rubber Grip Ring
The final assembly step for the turret assembly is to
reinstall the black knurled-rubber grip ring around the
outer perimeter of the revolving turret and secure it in
place with a suitable color-matching adhesive. Black
silicone RTV is a good choice of adhesive here, since it
will bond well with the metal of the revolving turret as
well as to the black knurled-rubber grip ring.
Additionally, any of the inevitable squeeze-out that is
not removed will not be visible. Apply two dabs of black
silicone RTV (item 7 of
perimeter of the revolving turret, spaced approximately
180° apart (see
Figure
44).
Figure 44 – Apply black silicone RTV to revolving turret
Carefully reinstall the knurled-rubber grip ring onto the
outer perimeter of the revolving turret, making sure to
not stretch or damage the grip ring (see
Appendix
1) onto the outer
Figure
45).
Revision 3
Page 15 of 19