Olympus BX51 사용 설명서 - 페이지 16

{카테고리_이름} Olympus BX51에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX51 40 페이지. System
Olympus BX51에 대해서도 마찬가지입니다: 운영 매뉴얼 (17 페이지), 사용 설명서 (34 페이지), 사용 설명서 (37 페이지), 운영 매뉴얼 (11 페이지)

페이지 인쇄

3-3 Stage

Fig. 14

Fig. 15

Fig. 16

Placing the Specimen

# The dimensions of the slide glass should be 26 x 76 mm with thick-

ness of 0.9 to 1.2 mm, and the cover glass should have thickness of

0.17 mm.

# When observing very large specimens, remove the slide holder and

place the specimen directly on the stage.

Microscopy with Double-Slide Holder (Fig. 14)

1. Turn the coarse adjustment knob @ to lower the stage.

2. Open the spring-loaded curved finger ² on the slide holder and place

one or two specimen slides on the stage from the front.

3. After placing the sides as far as they will go, gently release the curved

finger.

Microscopy with Single-Slide Holder (Fig. 15)

The specimen side can easily be placed by sliding it into the slide holder

from the front.

Examining a whole specimen

Use one of the thin slide holders listed below that cause less interference

with the objectives*.

· U-HRD-4

· U-HLD-4

* The applicable objectives are ones with 40X or less magnification (except

Apo series).

Using an Oil Immersion Objective

Adsorption of immersion oil can cause the specimen to drift. In such

cases, it is recommended to use the optional BH2-SCB-3 specimen clip

³ for oil immersion objectives. (Fig. 16)

Using an Oil Immersion Condenser

It may be effective to use the optional U-SVRO (right-hand knob) or U-

SVLO (left-hand knob) slotted stage which prevents close contact be-

tween the specimen and stage.

· U-HLS-4