Olympus BX51M 사용 설명서 - 페이지 19
{카테고리_이름} Olympus BX51M에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX51M 36 페이지. System metallurgical microscope
페이지 인쇄
@
²
Fig. 25
@
Fig. 26
Fig. 27
Fig. 28
4
Using Eyepiece Micrometer Disks
Eyepiece micrometer disks can be inserted into the WHN10X-H (or
WHN10X) eyepieces.
However, if the eyepiece does not have the helicoid adjustment facility
and your eyesight is poor, you may have difficulties in focusing on the
eyepiece micrometer disk. In this case, it is recommended to look into
the eyepiece through your eyeglasses.
Use 24 mm dia. x 1.5 mm micrometer disks.
Following Fig. 25, remove the micrometer mounting frame ² from the
eyepiece and place a micrometer disk @ into the mounting frame.
Re-attach the micrometer mounting frame in the original position.
5
Selecting the Light Path of theTrinocular Tube
Slide the light path selector knob @ to select the desired light path.
Trinocular
Tube
Pushed In
U-TR30-2
Binocular 100%
U-SWTR-3
U-ETR3
Binocular 100%
U-SWETR
U-SWETTR2 Binocular 100%
6
Adjusting the Tilt (with the U-TBI3/SWETTR2)
}Adjust the height and tilt angle of the observation tube to obtain the most
comfortable viewing position.
Holding the binocular section with both hands, raise or lower it to the
desired position.
# Never attempt to force the binocular section past the upper or lower
stop position. Applying excessive force could destroy the limiting
mechanism.
# The U-TBI3 cannot be used in combination with any intermediate
attachment.
# When darkfield observation of scratches and/or dust on a mirror
surfaces is performed with the U-TBI3, ghost images may appear.
With the U-ETBI (Fig. 28)
The U-ETBI is an ergonomical observation tube with normal field ca-
pable of tilting adjustment with an erect image. The eyepiece position
can be adjusted by 45 mm toward the front and rear.
Light Path Selector Position
Intermediate
Binocular 20%
TV, photo 100%
TV, photo 80%
TV, photo 100%
Binocular 20%
TV, photo 80%
BX51M
(Fig. 25)
(Fig. 26)
Pulled Out
(Fig. 27)
16