Olympus BX53 사용 설명서 - 페이지 6

{카테고리_이름} Olympus BX53에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX53 48 페이지. Polarizing microscope
Olympus BX53에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지), 사용 설명서 (36 페이지)

페이지 인쇄

Safety Symbols

The following symbols are found on the microscope. Study the meaning of the symbols and always use the equipment

in the safest possible manner.

Symbol

Caution indications

Caution labels are placed at parts where special precaution is required when handling and using the microscope. Always

heed the cautions.

If a caution label is dirty or peeled off, contact Olympus for the replacement or other inquiry.

Getting Ready

Fig. 2

Indicates that the surface becomes hot, and should not be touched with bare hands.

Indicates a non-specific general hazard. Follow the description given after this symbol or in

instruction manual.

Indicates that the main switch is ON.

Indicates that the main switch is OFF.

Caution label

Lamp housing

position

[Caution against high temperature]

Caution label

Rear panel

position

[Caution against high temperature]

1. A microscope is a precision instrument. Handle it with care and avoid

subjecting it to sudden or severe impact. Also note that the microscope

does not have a waterproof construction.

2. Do not use the microscope where it is subjected to direct sunlight, high

temperature and humidity, dust or vibrations. (For the operating conditions,

refer to section 8, "SPECIFICATIONS".)

3. When moving the microscope, remove the observation and specimen

and carefully carry the microscope by holding the grasping part on the

rear of the arm and the front part of the base as shown in Fig. 2.

CAUTION

· Even when moving the microscope along the desktop surface, be sure

· When the microscope needs to be packaged for forwarding to a remote

Please do not lift up the microscope by holding the bottom side of the

power supply cover (black) located on the rear panel.

4. When the accessories of this product are used, make sure that the system

height does not exceed 1 meter. Otherwise, the stability of the device will

be lost.

Explanation

To prevent damage to the microscope, never hold it by the stage

or coarse/fine adjustment knob.

to remove the specimen in advance.

location, contact Olympus.