Olympus CX41 사용 설명서 - 페이지 26

{카테고리_이름} Olympus CX41에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus CX41 32 페이지. System microscope
Olympus CX41에 대해서도 마찬가지입니다: 개요 (7 페이지), 지침 (32 페이지)

페이지 인쇄

Fig. 27

Fig. 28

Fig. 29

Fig. 30

Attaching the Condenser Accessory

}

32.5 mm filter @ (32.5C, 32.5G533, 32.5LB45/150/200) can be

inserted in the CH2-FH or CX-AL ².

1. Push in the condenser accessory ³ all the way into the underside of

the condenser until it clicks.

2. When attaching the CX-AL, push it in so that the centering screw |

faces the front of the microscope to facilitate the manipulation.

Attaching the Cord Hanger (CH3-CH)

}By attaching the CH3-CH cord hanger on the rear of the microscope

frame, the power cord can be accommodated by winding around the

hanger.

Insert the hook ² of the cord hanger @ into the air vent groove on the

rear of the microscope by aligning the attaching position ³, and

clamp by sliding the cord hanger downward while pushing it against

the microscope with a strong force.

#Do not hold the microscope frame by the cord hanger when

carrying the microscope. Otherwise, the cord hanger may be

detached during transport, resulting in falling of the microscope

and personal injury.

Removal

To prevent electric shock, disconnect the power cord first. Also

make sure you use the provided Allen wrench, not a thin Allen

wrench.

Move the microscope frame to the edge of the table |, apply an

Allen wrench ƒ onto the lower part of the cord hanger @, and

move the entire hanger upward by pushing the Allen wrench

toward the directions 1 and 2 to remove. (Fig. 30)

(Figs. 27 & 28)

(Figs. 29 & 30)