Olympus DP21 사용 설명서 - 페이지 20
{카테고리_이름} Olympus DP21에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus DP21 28 페이지. Microscope digital camera
Olympus DP21에 대해서도 마찬가지입니다: 빠른 작동 매뉴얼 (2 페이지)
페이지 인쇄
Under certain conditions, performance of the camera may be adversely affected by factors other than defects. If problems
occur, please review the following list and take remedial action as needed. If this digital camera is combined with
standalone connection kit DP21-SAL, check the instruction manual of DP21-SAL as well.
If you cannot solve the problem after checking the entire list, please contact Olympus for assistance.
Camera head does not work.
Nothing is displayed on the display.
Live image is not displayed.
Still images cannot be recorded.
16
Downloaded from
ManualsNet.com
TROUBLESHOOTING GUIDE
Problem
The main switch of camera head is
OFF.
The AC adapter is connected improp-
erly.
*Only when using the camera cable
(9pins-4pins).
The camera cable is connected im-
properly.
The display is not ON.
The display cable is connected im-
properly.
The display resolution is set improperly. Set the correct display resolution.
The camera cable is connected im-
properly.
The microscope illumination is off. The
microscope is not set to the camera
light path. The illumination or specimen
focusing is adjusted improperly.
The ISO speed or exposure time is set
improperly.
The DP2-TWAIN or cellSens / OLYMPUS
stream is processing recording.
The cellSens / OLYMPUS stream is
processing file save, etc.
The computer memory is insufficient.
search engine
Cause
Set the main switch of the camera
head to ON.
Connect the AC adapter correctly to
the camera head and plug the power
cord firmly into a power outlet.
Connect the camera cable correctly.
Turn the display ON.
Connect the display cable correctly.
Connect the camera cable correctly.
Turn on the microscope illumination,
adjust the lighting and focusing cor-
rectly, and select the camera light path.
Set the ISO speed, exposure mode,
exposure time and level properly.
Wait until the recording processing
completes before starting recording of
the next image. In certain cases, it may
be required to press the Cancel but-
ton on the status bar and record the
image again.
Wait until processing completes before
starting recording of the next image.
Exit from other software before retry-
ing recording.Save the images which
you did not save.
Remedy
Page
9
12
11
---
---
---
11
---
---
---
---
---