Olympus MX61 조립 설명서 - 페이지 9

{카테고리_이름} Olympus MX61에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus MX61 49 페이지. 200mm/300mm compatible semiconductor/fpd inspection microscopes

페이지 인쇄

Getting Ready

Fig. 3

Maintenance and Storage

1. To clean the lenses and other glass components, simply blow dirty away using a commercially available blower and wipe

gently using a piece of cleaning paper (or clean gauze).

If a lens is stained with fingerprints or oil smudges, wipe it gauze slightly moistened with commercially available absolute

alcohol.

Since the absolute alcohol is highly flammable, it must be handled carefully.

Be sure to keep it away from open flames or potential sources of electrical sparks –– for example, electrical

equipment that is being switched on or off. Also remember to always use it only in a well-ventilated room.

2. If any part of the equipment (other than glass components) gets dirty, with it with a clean cloth.

If the party is extremely dirty, do not attempt to use organic solvents to clean it; instead, use a soft, lint-free cloth slightly

moistened with a diluted neutral detergent.

3. Never disassemble any part other than instructed of the microscope. This could result in malfunctions or reduced

performance.

4. When not using the microscope, keep it covered with a dust cover. Make sure the lamp housing is cool before covering

the microscope.

5. When disposing of the microscope. Check the regulations and rules of your local government and be sure to

observe them.

Applicable Standards

1. These devices are in compliance with or certified by the following standards.

2. Although these devices are designed for use in industrial environments, their full performances may not be manifested if

they are not operated properly. Be sure to handle them properly as instructed in this manual.

These devices are designed for use in industrial environments (Class A devices).

Using them in a residential environment may affect other equipment in the environment.

CE marking

This device complies with the requirements of both directive 89/336/EEC concerning electromagnetic compatibility

and directive 73/23/EEC concerning low voltage. The CE marking indicates compliance with the above directives.

1. Do not use the microscope where it is subjected to direct sunlight, high

temperature and humidity, dust or vibrations. (For the operating conditions,

refer to chapter 8, "SPECIFICATIONS " in the Instruction Manual.)

2. A microscope is a precision instrument. Handle it with care and avoid

subjecting it to sudden or severe impacts. Never attempt to rotate the

motorized revolving nosepiece by hand; otherwise, the gear or other parts

may be damaged.

3. When moving the microscope, detach the observation tube, stage, lamp

housing and specimen to reduce the total system weight, and then

insert the two provided carrying rods @ firmly into the left and right side

panels. Two persons are needed to carry the microscope; one should

hold the front holding section ² and a carrying rod and the other person

should hold the rear holding section ³ and the other carrying rod. Be

sure to move the microscope cautiously. (The microscope frame weight

is about 30 kg, or 66 lbs.)

}After movement, remove the carrying rods, and either have the customer

retain them without losing or attach them to the two screw holes on the

rear of the microscope. Attach the provided screw hole caps to the screw

holes left by removing the carrying rods.

# Do not change the position of the microscope by sliding it on the

desktop surface; otherwise, the rubber feet will be damaged.

4. Be sure to attach the transport clamping plate(s) to the stage before

transporting it.

MX61/MX61L