Olympus U-25ND6 사용 설명서 - 페이지 13

{카테고리_이름} Olympus U-25ND6에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus U-25ND6 42 페이지.

페이지 인쇄

Objectives for Various Observation Modes

UPlanApo

PlanApo

UPlanFl

UApo

¦ : Recommended combination.

¦* : Usable but image be dark depending on NA.

–

: Not usable or applicable objective is not available.

¦** : A phase contrast objective (Ph) is necessary for phase contrast observation. The Ph objective is not

Turning the Power Supply Unit On

Set the main switch to " I " (ON). The arc image will stabilize in 5 to 10 minutes after ignition.

}The mercury burner may not be ignited from the beginning due to variance between individual products. In this case, set

the main switch to "

# To extend the mercury burner life, do not turn the mercury burner off for 15 minutes after ignition.

# The mercury burner cannot be ignited until the mercury vapor has cooled down and liquefied. Before re-igniting

a mercury burner, wait for about 10 minutes after the last time it was turned off.

}For the shake of safety, the power supply to the lamp housing is shut down if the lamp housing is opened while the

burner is on. If this happens, set the main switch to "

Do not open the lamp housing until it has cooled down enough.

# To reset the hour counter, hold its reset button until "000.0" is displayed.

Objective

10X

10XO

10XW

20X

20XO

40X

40XO I

60X

60XW

100XO I

40X

60XO

100XO

10X

20X

40X

60XOI

100XO, OI

20X

20XW/340

40X

40XO I

40XW/340

available for the UPlanFI100XOI.

" (OFF), wait for 5 to 10 seconds, then set it again to " I " (ON).

Reflected Light Fluorescence

U, V, BV

B, IB, G, IY

–

*¦*

" (OFF), wait for ore than 10 minutes, then set it again to " I " (ON).

Phase Contrast

Transmitted Light

Difference

Nomarski DIC

–

**¦**

–

**¦**

–

**¦**

–

**¦**

–

**¦**

–

**¦**

–