Olympus U-DO3 사용 설명서 - 페이지 23

{카테고리_이름} Olympus U-DO3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus U-DO3 40 페이지. For 2, 5, 9, 10 and 13 persons
Olympus U-DO3에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지)

Olympus U-DO3 사용 설명서
b
1
a
d
c
1
a
3

Attaching the side viewer

1
Remove the cap on the observation attachment body a and the cap
from the mount b on the side viewer.
2
Return the vertical direction of the side viewer where the stand is
attached to the original direction. Insert b of the side viewer into the
observation attachment body a completely to the end.
3
While holding the base c of the stand firmly with your hand, rotate
the mount ring d to secure the side viewer to the observation
attachment body.
After the mount ring d is rotated completely, make sure
NOTE
that the stand is installed on the desk securely. Insert a
sheet of paper between the base of the stand and the
desk. If the paper touches three rubber legs, the stand is
installed securely. If the paper does not touch even one
rubber leg, perform
4

Attaching the observation tube

b
1
Attach the observation tube b for the main observer to the tube mount
c
a on the observation attachment body at the main observer position,
and tighten the clamping screw c to secure the observation tube.
Attach the observation tube so that the side surface d of the
TIP
e
observation attachment body is parallel to the side surface
d
attached in the proper direction, the orientation of the image
observed by assistant observers differs from that observed by
the main observer. (For the orientation of the observed image,
see "1 Configuration of the discussion system and orientation
of observed images" (page 5).
again.
3
e of the observation tube. If the observation tube is not
19