Olympus U-DO3 사용 설명서 - 페이지 6
{카테고리_이름} Olympus U-DO3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus U-DO3 40 페이지. For 2, 5, 9, 10 and 13 persons
Olympus U-DO3에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지)
페이지 인쇄
Safety precautions
If the product is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the
product may also be damaged. In addition, the product may also be damaged. Always use the product according to this
instruction manual.
The following symbols are used in this instruction manual.
CAUTION
NOTE
TIP
CAUTION - Installation of the product -
Install the product on a sturdy and level desk.
With this system, the product is installed on the multiple desks which are arranged side by side. All desks must be
sturdy and level. Also, take proper measures to fix the desks to avoid them from moving.
CAUTION - Electric safety -
Always use the power cord provided by Olympus.
If the proper AC adapter and the power cord are not used, the electric safety and the EMC (Electro-Magnetic
Compatibility) performance of the product cannot be assured. If no power cord is provided, please select the proper
power cord by referring to the section "Proper selection of the power cord" at the end of this instruction manual.
Always connect the ground terminal.
Connect the ground terminal of the power cord and that of the power outlet. If the product is not grounded, our
intended electric safety and EMC performance of the product cannot be assured.
Do not use the product in close proximity to the sources of strong electromagnetic radiation.
Proper operation may be interfered. The electromagnetic environment should be evaluated prior to operation of the
product.
Disconnect the power cord in case of emergency.
In case of emergency, be sure to unplug the power cord from the power cord connector on the product or from the
wall power outlet. Install the product at the location where you can reach the power cord connector or the power outlet
at hand to disconnect the power cord quickly.
Do not connect or disconnect the power cord, cables and units while the power is on.
CAUTION
Keep the power cord and cables well away from the lamp housing.
If the power cord and cables contact a hot area of the lamp housing, they could melt and cause electric shock.
Do not touch the product with wet hands.
In particular, if you touch the main switch of the power unit or the power cord with a wet hand, electric shock, ignition
or failure of the product may be caused.
2
: Indicates a potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
: Indicates a potentially hazardous situation which, if not avoided, may result in
damage to the product or other property and/or may cause problems.
: Indicates the useful knowledge or information for use.
- Prevention of electric shock -