AXIXTECH SAF205H 설치 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} AXIXTECH SAF205H에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AXIXTECH SAF205H 16 페이지. Electronic handheld siren

WIRING

Use wires that are capable of handling the required current. Route the wires properly to prevent

wear, overheating and interference with air bag deployment. Ensure that all connections are tight

and double check wiring before connecting to the vehicle battery.

Electrical connections to the unit are made by using block plugs and screw terminals. Route

all wiring to the siren and secure onto block plug terminals, then plug onto the siren. The

plug can be easily removed without unwiring when the unit requires servicing. The power

supply for the fused amplifier (12-P plug) must be capable of delivering peak currents up to

50A for adequate short circuit protection and proper operation. It is recommended to wire

directly to the vehicle battery.

WARNING: ensure that all wires are firmly secured onto the block plug, and plug is firmly

secured onto the siren.

Wire Size and Termination – The "AMPLIFIER CONNECTIONS" diagram shows the

minimum size of the wires used for each connection, along with recommended lead color.

If the wire is longer than 10 ft., use the next larger size.

ENA Input Connection – This serves as the power switch for the entire unit. Connect to a

positive circuit controlled by the vehicle ignition switch, usually a terminal at the vehicle

fuse panel. It is not recommended to make permanent power connection as this may drain

battery.

HRT Input Connection – The Horn Ring Transfer input allows activation by an external

source of either the Horn or other function. It can be set for positive or negative switching,

see DIP-SW1-1 (HRT_N) under OPTION SWITCHES section.

PKL Input Connection – The Park Kill input may be connected to the vehicle door switch

or other switching device to turn off any siren tone when activated. It can be set for

positive or negative switching, see DIP-SW1-2 (PKL_N) under OPTION SWITCHES

section.

RAD Input Connection – Connect to radio output terminals or its speaker. The Radio

volume can be adjusted by using a small flat blade screwdriver.

Speaker Output Connection – Both connections must be used. Two speakers may be

connected in parallel.

VID Output Connection (Option) – A Video Camera trigger output is activated when ever

the unit is in SIREN or HF mode. (Not available in this model).

- 5 -

SAF205H Siren_v.1