Olympus PFL-E01 사용 설명서 - 페이지 11

{카테고리_이름} Olympus PFL-E01에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus PFL-E01 29 페이지. Electronic flash waterproof case for the fl-36

Preparing the case

Before shooting, prepare the case as described below.

The Case is provided with a diffuser to reduce the intensity of the light emitted by the flash.

You can use the diffuser to reduce the amount of flash light directed at the subject, to minimize

shadows produced by the illuminated subject, or reduce the light intensity of the flashlight.

Attach or detach the diffuser as shown in the following illustrations.

CAUTION

：The diffuser makes it possible to reduce flash intensity by about 3 steps

compared an undiffused flash. The diffuser is especially useful when you

need to temporarily reduce the flash intensity for close-up macro shooting.

To perform underwater TTL shooting using this case, connect the underwater TTL cable

between this case and the camera case. Connect the hot shoe cable (provided with this

case) between the TTL cable connector in the camera case and the camera's hot shoe.

1) Connecting the underwater TTL cable

After making sure the Case is dry, loosen and remove the TTL cable connector cap on

the Case so you can connect the underwater TTL cable to the TTL cable connector on

the Case (you can use the connector at either end of the cable). Before connecting,

apply a thin layer of the silicone grease provided with the Case to the thread of the

TTL cable connector.

E-9