Olympus PT-030 사용 설명서 - 페이지 21

{카테고리_이름} Olympus PT-030에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus PT-030 44 페이지. Underwater case

Insertion of silica gel

Before sealing the Case,

insert the accessory silica

gel bag (for prevention of

fogging)

between

bottom of the camera and

the Case. Insert the bag

with the glued longer side

to the inside.

CAUTION

: • Insert the silica gel all the way at the specified

location and with the specified orientation. When the

orientation is not correct, the silica gel bag will be

caught when the Case is sealed and water leakage

will be caused.

• Attempting to seal the Case with the bag inserted only

part of the way will cause the silica gel bag to get caught

by the O-ring and water leakage will occur.

• Once silica gel has been used, the moisture

absorption performance will be impaired. Always

exchange the silica gel when the Case is opened and

closed.

After closing the rear lid of the

Case, fit the Case's mode dial

(located on the front lid of the

Case,) over the top of the digital

camera's mode dial.

Advice • After fitting the Case's mode dial knob, turn the knob to

make sure that the camera's mode dial switches before

closing the Case tightly.

• If the camera's mode dial does not turn when turning the

mode dial knob, gently push in the knob while turning it.

the

Pay attention to the orientation.

E-20

Mode dial

knob