Olympus PT-E02 사용 설명서 - 페이지 15

{카테고리_이름} Olympus PT-E02에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus PT-E02 41 페이지. Underwater case for digital camera e-330

Removing the TTL cable connector cap

TTL cable

Remove.

connector cap

Turn counter clockwise.

Insert into the

connector.

---- How to attach the TTL cable connector cap to the case ----

Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL

cable connector. To secure the cap, gently turn it clockwise until it stops.

CAUTION

: • If the TTL cable connector cap is loose, water penetration may result. Be

sure to gently turn the cap until it stops to make sure it is firmly secured.

Do not turn or tighten the TTL cable too hard. If it is too tight, it may be

difficult to loosen and remove it.

❈ For details on the TTL cable and hot shoe cable, refer to the instruction manual provided

with the Electronic Flash Case.

If the threaded sections of the TTL cable and TTL cable connector stick to each other, the

cable may disconnect from the connector. To prevent this, apply O-ring silicon grease

(provided with this case) to the threaded sections.

For details, see the maintenance description on page E-32 of this manual.

CAUTION

: • If you cannot disconnect the TTL cable, do not use force to disconnect it.

Contact Olympus for support.

To perform TTL flash shooting in combination with the

separately available Electronic Flash Case, remove

the TTL cable connector cap as described below.

Remove the TTL cable connector cap from the

Case.

Connect the Electronic Flash Case's underwater

TTL cable to the TTL connector on the Case.

Underwater

TTL cable

Use this mark to

align the position.

Turn the threaded section of the connector

clockwise lightly until it is stopped.

Put the cap

on the case.

E-13

Gently turn the cap

clockwise until it stops.