Olympus PT-E02 사용 설명서 - 페이지 22

{카테고리_이름} Olympus PT-E02에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus PT-E02 41 페이지. Underwater case for digital camera e-330

Insert the digital camera in the Case.

Load the digital camera in the Case after checking the following:

• Is the digital camera turned OFF?

• Is a medium loaded in the digital camera?

• Is the battery fully charged?

• Have the strap, lens cap and filter been removed from the digital camera?

• Is the camera table provided with the Case attached to the tripod screw hole on the

bottom of the digital camera?

• Has the viewfinder eyecup of the finder of the digital camera been removed?

• Is the zoom gear attached to the camera lens?

• Is the camera's LCD monitor stored on the camera side?

• Is the camera' eyepiece shutter open?

(1) Pull out the zoom dial and mode dial on the Case (pulling out the mode dial also pulls up

the power switch lever) so that they do not get in the way while loading the digital camera.

Set the power switch lever and eyepiece shutter lever as shown below.

(Power switch lever)

Set to the 6:00 o'clock position.

(2) Remove the TTL cable connector cap from the hot shoe connector on the top left

corner of the inner side of the front lid of the Case. Connect the hot shoe cable to the

connector.

Remove the cap by turning

it counterclockwise.

CAUTION

: • When screwing in the hot shoe connector clamping screw, place the Case

upside down. Be careful not to drop the Case.

(Eyepiece shutter lever)

Set to the 4:00 o'clock position.

E-20