Olympus PT-E03 사용 설명서 - 페이지 28
{카테고리_이름} Olympus PT-E03에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus PT-E03 41 페이지. Underwater case for digital camera e-410/e-400
페이지 인쇄Final Test
The final test after loading the camera is explained below. This is the only way to eliminate worry about
possible entry of water! Always perform this test. It can be performed easily in a water tank or a bathtub.
The required time is about five minutes.
Simple water immersion test
1 Place the Case slowly into
the water.
2 At first, immerse the Case
for only three seconds.
3 Check that no water has
entered the Case.
4 Next, immerse the Case for
30 seconds.
5 Check that no water has
entered the Case.
En
6 Next, check by immersing
for three minutes.
7 This is the final check. Has
the silica gel become moist?
8 If there is no water leakage
and everything is functioning
correctly, you are ready to
start shooting underwater.
EN 27
Explanatory image
As the Case is transparent, waterdrops
entering into it can be confirmed easily.
In case of trouble with the O-ring, three
seconds is enough for water to enter. Are there
air bubbles coming out between the lids?
Please check carefully.
Remove the Case from the water and check
that no water has accumulated at the bottom of
the Case.
Is there any water trickling down?
Check carefully for air bubbles!
Do not perform any operation yet, but just
observe.
Remove the Case from the water and check
that no water has accumulated at the bottom of
the Case.
Confirm very carefully.
Check carefully for air bubbles!
Try operation of the buttons used frequently.
Check carefully for air bubbles!
If there is still no entry of water, everything is
OK!
This is very important!
Has the silica gel become moist?
Please check carefully!
As the interior can be seen, the inspection for
entry of water also can be made easily!
Now everything is all right!
Have a nice dive!
Hints