Olympus PT-EP13 사용 설명서 - 페이지 13

{카테고리_이름} Olympus PT-EP13에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus PT-EP13 25 페이지.

How to Apply Grease to the O-ring

1 Apply only Olympus

exclusive lubricant to each

O-ring.

2 Spread the lubricant onto

the entire circumference of

the O-ring.

3 Check that the O-ring is free

of scratches or unevenness.

CAUTION:

• Always perform maintenance of the waterproof function even when the Case has been opened every

shooting. Neglecting this maintenance may become the cause of water leakage.

• When the Case is not to be used for a long time, remove the O-ring from the groove to prevent deformation

of the O-ring, apply a thin coat of silicone grease, and store it in a clean plastic bag or the like.

Hair

Confirm that no foreign matter is in the gap and then fit the O-ring. At this time, confirm that the O-ring

does not stick out from the groove.

When sealing this product, make sure that no hairs, fibers, sand particles or other foreign matter stick

not only to the O-ring, but also to the contact surface (front cover). Even a single hair or a single grain of

sand may cause water leakage. Please check with special care.

Examples of foreign matter sticking to the O-ring

Fibers

Make sure that your fingers and the O-ring are

free of dirt, then squeeze the appropriate

amount of exclusive lubricant onto a finger to

spread onto the entire circumference of the O-

ring (approx. 15 mm is adequate).

Spread the grease onto the entire

circumference of the O-ring using 3 fingers.

Be careful not to use excessive force as this

may stretch the O-ring.

After spreading the lubricant, check visually

and by touch that the O-ring is not scratched

and that its surface is flat. If it is damaged in

any way, replace it with a brand-new O-ring.

Grains of sand

EN 12