Olympus SP-310/SP350 사용 설명서 - 페이지 5

{카테고리_이름} Olympus SP-310/SP350에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus SP-310/SP350 44 페이지. Underwater case

For Prevention of Water Leakage Accidents

When water leakage occurs while this product is being used, repair of

the camera housed in this product may become impossible. Please

observe the following cautions for use.

1. When sealing this product, make sure that no hairs, fibers, sand

particles or other foreign matter stick not only to the O-ring, but

also to the contact surface. Even a single hair or a single grain of

sand may cause water leakage. Please check with special care.

Examples for foreign matter sticking to the O-ring

Hair

2. The O-ring is a consumption product. Please replace it at least

once a year by new one. Also perform maintenance for every use.

3. Deterioration of the O-ring will progress according to the use

conditions and the storage conditions. Immediately replace the O-ring

by a new one if it is damaged, shows cracks, or has lost its elasticity.

4. At the time of O-ring maintenance, clean the inside of the O-ring

groove and confirm the absence of dirt, dust, sand, and other

foreign matter.

5. Apply the specified silicone O-ring grease to the O-ring.

6. The waterproof function is not effective when the O-ring is not

installed correctly. When installing the O-ring, take care that it does

not project from the groove and that it is not twisted. Also, when

sealing the Case, close the lid after confirming that the O-ring has

not come out of the groove.

7. This product is an airtight construction made of plastic (polycarbonate).

When it is left for a long time in a car, on a boat, at the beach, or at

other places reaching a high temperature, or when it is subjected for a

long time to uneven external force, it may be deformed and the

waterproof function may be lost. Pay sufficient attention to temperature

control. Also do not place heavy objects onto the product during

storage or transport, and avoid unreasonable storage.

8. When the O-ring contact surface is pressed strongly from the

Fibers

E-4

Grains of sand