Olympus XA2 사용 설명서 - 페이지 6

{카테고리_이름} Olympus XA2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus XA2 7 페이지. Proseal instructions for all olympus xa style cameras

Once the latch end piece is totally dry (30 minutes or so), press it against the film door to seal

it.

For those of you with first series XA models (XA, XA1 or XA2), you may now replace your

pressure plate. First I slide the left hand slot beneath its retaining button and next I carefully

position the opening over the other retaining button and push gently downward from the top

until I hear or feel it click into place.

The top strip isn't a difficult problem at all. Simply cut two pieces. There is a ledge at the

point of the bend. Please look at how I do this:

Now you're finished and you can re-assemble your camera by reversing the steps above. You may

use the dimensions below to cut your seal pieces.

(1) If you want to re-paint your film door, a good spray paint is: Krylon #1613 Semi Flat Black.

(you may also use this to re-paint the inside of the door with the pressure plate and all seal

material removed). If your film door needs sanding, 400 or 800 grit wet/dry sandpaper should

be just fine. Be sure to wash the film door in warm soapy water well and/or wipe it down with

Naphtha before you sand it. The oils from your hands and fingers collect on the film door.

Sanding the door before removing the oils only forces them into the old paint more deeply,

making it more difficult to remove them later. Oils will cause "fisheyes" in the paint.

(2) Dimensions for seal pieces: First series door strips: bottom strip—112mm x 2.5mm. Top

strip—70mm x2.5mm (unless your camera's strip goes all the way to the end...then it is apx

112mm, cut at the break as shown above). First Series hinge end seal—42mm x 8.5mm with a

cutout of 8mm x 3mm spaced 12mm from the left side/22mm from the right side. Second

series hinge end seal—46mm x 6mm with a cutout of 8mm x 3mm spaced 15mm from the left

side/23mm from the right side. Latch end seal (all models) 2mm x 47mm. Material to use:

First Series door & hinge seal: 1mm fabric seal or 1mm foam. Second series hinge end seal:

1.5mm open-celled foam.

(3) Lick the adhesive? Yes! Whether using foam or fabric, this will temporarily de-activate

the adhesive. Then you can position the seal just where you want it to be. When it is dry,

stick it down for good.

About the XA film door and the top seal piece:

Two 1mm fabric pieces set into place

show how to install this piece in the

easiest fashion.

~~NOTES~~