Olympus OEP-5 사용 설명서 - 페이지 9

{카테고리_이름} Olympus OEP-5에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus OEP-5 40 페이지. Color video printer

페이지 인쇄

Chapter 2 Installation and Connection

Prepare this instrument and compatible equipment

(shown in the "System Chart" on page 30 in

"Appendix") before each use, and refer to the instruction

manuals of each system component. Install and connect

the equipment as follows:

In addition, this "INSTRUCTIONS (BASIC)" explains

the EVIS EXERA II Video System Center (CV-180).

For other equipment, refer to "Chapter 2 Installation and

Connection" in "INSTRUCTIONS (ADVANCED)."

WARNING

• Review this chapter thoroughly before each use. If the

equipment is not properly prepared before each use,

equipment damage, patient and operator injury and/or

fire can occur.

• When non medical electrical ancillary equipment is

used, connect its power cord via an isolation

transformer prior to connecting it to this instrument.

Failure to do so can cause electric shock, burns and/or

fire.

• Use this instrument, the remote control unit (MAJ-

898) and color printing pack (UPC-55) under the

conditions described in "Operating/Transport/Storage

Environment" on page 32 and

"Specifications" on page 32 in "Appendix".

Otherwise, improper performance, compromised

safety and/or equipment damage may result.

• Connect the power cord to a wall mains outlet, and the

connecting cables to each equipment firmly. If

connections are not made correctly/firmly, fire or

electric shock may result.

CAUTION

• Turn OFF all equipment before connecting them.

Otherwise, equipment damage or malfunction may

result.

• Use appropriate cables. Otherwise, equipment

damage or malfunction may result.

• The cables should not be sharply bent, pulled, twisted

or crushed.

• When you connect another piece of video equipment

between this instrument and the video system center,

be sure not to turn off the power of the video

equipment while this instrument is being used. If you

turn off the power of the video equipment, the video

signal may not be input to this instrument properly,

and this instrument may not work correctly, depending

on the video equipment connected.

2.1 Installation of the

Color Video Printer

(OEP-5)

CAUTION

• Do not place any object on the top of this instrument.

Otherwise, equipment damage may result.

• Keep the ventilation grilles of this instrument clear.

Blockage may cause overheating and equipment

damage.

• Place this instrument on a stable and level surface.

Otherwise, this instrument topple down or drop.

• If a trolley other than the mobile workstation (WM-

NP1, WM-WP1) is used, confirm that the trolley can

withstand the weight of the equipment installed on it.

• Do not use this instrument in an inclined position.

Unstable operation, damage and/or abnormal printing

may result.

• Do not install this instrument near a source of strong

magnetic radiation (microwave treatment device,

short wave treatment device, MRI, radio equipment,

etc.). Otherwise, this instrument may cause

malfunction.