Axminster 103629 사용 설명서 - 페이지 8
{카테고리_이름} Axminster 103629에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster 103629 20 페이지. 7 inch. engineer series
페이지 인쇄1.
Move saw bow to proper height position and
lock in place by shutting off the hydraulic
cylinder valve.
2.
Confirm that blade tension is set properly. To
adjust, see section titled Adjusting Blade
Tension.
3.
Open back wheel cover by loosening lock
screws.
4.
Run saw and observe blade. Blade should run
next to but not tightly against wheel flange.
5.
If need to adjust blade track, remove the
screws of cover (A, Fig.16).
6.
Loosen bolts (B) a little bit.
7.
Turn setscrew (C) while observing blade
tracking on wheel. Turn setscrew (C)
clockwise to track blade closer to the wheel
flange. Turn set screw counter-clockwise to
track blade away from the wheel flange.
8.
Once tracking is set, tighten bolts (B).
9.
Recovery the cover (A).
C
Adjusting Blade Guide Bearings
CAUTION !
This machine is designed and intended for use
with blades that are 19mm width, 0.9mm
thickness and 2285mm length. Use of blades
with different specification may cause inferior
performance.
1.
Disconnect machine from the power source.
2.
Raise arm up to proper position and lock in
place by turning off the hydraulic cylinder valve.
3.
Loosen hex cap screw (A, Fig. 17) and adjust
assembly so that back roller bearing is
approximately 0.08mm-0.12mm from the back
of the blade.
Fig. 16
4.
Turn nut (B) to adjust eccentric bearing shaft to
the blade (the other side bearing shaft is fixed).
Blade should still move up and down freely
when grasped. Warning! Make sure power is
disconnected and hands are protected before
handling blade. Be sure that blade teeth do not
interfere with the roller bearings.
5.
Connect machine to the power source.
Adjusting Bow Angle
For miter cutting, it needs to swivel saw frame to
A
desired angle. The cutting angle for this machine is
0 ~ 60° on the left side, 0~45° on the right side.
There is a bar (A Fig18) for frame to stop at zero
position on right side swiveling moving, if need to
cut in the left side that have to pull out the zero
position lock bar (A) then swivel frame to set
desired angle at the left cutting. Loosen the frame
tighten lock handle (B, Fig.18) and wing nut (D, Fig.
B
19) at the other side before swiveling.
Swiveling saw frame and seat to desired angle
which indicated with angle scale (C). Then Tighten
handle screw and wing nut eventually.
C
A
6
B
A
Fig. 17
Fig. 18
D
Fig.19
B