Axminster 504633 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Axminster 504633에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster 504633 2 페이지. Project pen kits

페이지 인쇄

ASSEMBLY, HINTS & TIPS

1. Layout the parts according to diagram

A, ensuring the turned Pen Barrels are

the same orientation as when mounted

on the mandrel.

Note: When removing the blanks from

the mandrel, use a felt tip pen to mark

the inside of each tube where they join to

maintain the grain or pattern alignment.

2. Make sure the Lower Pen Barrel and the

Nib are aligned and gently but firmly,

press together.

3. Repeat at the opposite end with the

Joining Bush (thread outwards).

4. Locate the Threaded Insert Bush (Note:

there is a small lead-in section on one

end; this goes in first) press firmly

into the bottom end of the Upper Pen

Barrel.

DIAGRAM A

Visit the Knowledge blog 'How To Make A Pen' for hints, tips and videos

knowledge.axminstertools.com/pen-turning

V I E W O U R F U L L R A N G E O F

P E N C A S E S A N D D I S P L A Y B O X E S O N L I N E

5. Ensure the Click Mechanism is correctly

oriented (the push button outward).

6. Slide the Silver Tube over the Click

Mechanism, introduce the Push Button

through the Clip and into the Clip

Retainer.

7. Insert the whole assembly into the

top of the Upper Pen Barrel and press

firmly together until the Clip Retainer

has trapped the Clip itself positively.

8. Introduce the Refill with Spring into the

bottom of the Upper Pen Barrel, feed

down through the Lower Pen Barrel,

and overcoming the Spring pressure

screw the two parts of the pen together.

9. Push the button to check the action of

the mechanism.

Axminster Tools, Axminster, Devon, EX13 5PH

A X M I N S T E R T O O L S . C O M

Tips/Hints

• Use a woodworking vice, one handed

bar clamp, arbor press or a dedicated

pen press.

• Press parts together slowly and steadily

• When pressing the parts together,

CHECK the parts are correctly aligned

with each other and straight. If the part

is crooked or misaligned, it will result in

a poor fit or render the pen unuseable.

• When laying out your pen barrel with

the parts, pay careful attention to keep

the pen barrels in the same orientation

as when on the mandrel. i.e. a pen barrel

may have a "top" and "bottom", now is

the time to be certain of the orientation.