Axminster ujk 106843 매뉴얼 - 페이지 14

{카테고리_이름} Axminster ujk 106843에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster ujk 106843 20 페이지. Universal dovetail jig

THROUGH DOVETAILS

Fig 25-26-27

4) Remove the now cut pin board & try for fit, see fig 28.

If the pins are too tight & won't slide into the dovetails

they can be recut to ensure a good fit. Simply load the

board back into the jig in exactly the same position, undo

the comb lock knobs & move the comb backwards by

turning the adjuster knobs clockwise, see fig 29. Try half

a turn to start with. Recut taking a very light skim & try

for fit again - repeat if still too tight, see fig 30.

Fig 28-29-30

Trouble shooting -

• Joint too tight - move comb backwards & recut

• Joint too loose - move fingers forward & recut new

board

• Gaps at one end of the joint - timber not square, comb

not sat flat on timber, see fig 31

• Excessive break out at the back of the cut - add a

sacrificial breakout board behind the cut, see fig 32-33

• Box sides not in line - timber not centralised or timber

not cut equally, see fig 34

Fig 31-32-33-34