Axminster ujk 106843 매뉴얼 - 페이지 6

{카테고리_이름} Axminster ujk 106843에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster ujk 106843 20 페이지. Universal dovetail jig

HALF BLIND DOVETAILS

• Max timber width - 300mm

• Min timber thickness - 13mm

• Max timber thickness - 25mm

Parts needed -

• Template B (half blind / sliding)

• 13.55mm Dovetail cutter

• ¾" (19mm) Guide bush

Both parts of this joint are cut at the same time,

(single pass)

1) Attach comb B (half blind / sliding) with the straight

fingers at the front of the jig, see fig 01-02. Use the

horizontal board to be cut to level the comb, see fig 03.

A support board with equal thickness to the cut board

may be required to support the comb when using

narrow boards, see fig 03.

Fig 01-02

Fig 03

Horizontal

boards

2) Before loading in the opposing vertical board use the

cutter set line mark on the right of the comb & a sharp

pencil to mark a line at the top of the board, see fig 04.

Fig 04

3) Load in vertically the first board on the left of the jig

pushing up to the underside of the comb & centralising

to the fingers, see fig 05. Slide the side stop towards the

right to make contact with the side of the material, see

fig 06 & lock in place.

Fig 05-06

4) Slide the horizontal board forward to meet the

vertical board and slide to the left to make contact with

the side stop, see fig 07. Then undo the comb lock knobs

& use the comb adjuster knobs to ensure that the finger

line on the comb is in line with the point where both

boards meet, see fig 08-09. Double check that the comb

is sat flat on top of the horizontal board & ensure that

both boards are level, see fig 10.

Fig 07

Equal distance